Well Pump Repair in Catonsville, MD

A dependable well pump keeps your home supplied with steady, reliable water pressure every day. When a pump starts to fail, you may notice pressure drops, sputtering, or interruptions that make normal routines difficult. We service and install both submersible pumps and jet pumps, and we make sure your entire well system works together the way it should. Our goal is to diagnose problems quickly, protect your well equipment, and keep your water supply running without interruption.

Types of Well Pumps We Install and Service

We work with the two most common pump styles found in this region: submersible pumps and jet pumps. Submersible pumps sit deep in the well and push water upward, while jet pumps are installed above ground and pull water from the well. Each system has its strengths based on the depth of the well and the layout of your plumbing, and we match the pump style to the demands of your home.

How We Diagnose Well Pump Issues

We start by checking the pressure tank, pressure switch, electrical supply, and flow rate to determine whether the problem is with the pump or another part of the system. We verify whether the tank is waterlogged, test the switch for proper cut-in and cut-out settings, and measure how the pump responds under load. This process lets us pinpoint the exact cause instead of replacing parts unnecessarily.

Signs Your Well Pump Is Failing

Some of the most common warning signs include low water pressure, air sputtering from faucets, short-cycling where the pump turns on and off rapidly, dirty or cloudy water, or complete loss of water. If you notice the pump running constantly, that is another sign the system is struggling to keep up and may need repair.

Preventative Maintenance We Recommend

Routine pressure checks, annual inspections of the pressure switch, and verifying that the pressure tank is holding the correct air charge all help extend the life of the pump. Keeping sediment filters clean and monitoring changes in water quality can also prevent strain on the system.

Common Causes of Pump Failure in This Region

In this area, we see pump failures caused by sediment buildup, worn motors, waterlogged pressure tanks, and failing pressure switches. High mineral content in local wells can also cause wear on pump components over time. Catching these issues early helps you avoid unexpected outages and protects your well equipment for the long term.

A well maintained pump system keeps your home’s water supply consistent, efficient, and ready whenever you need it.

Get a No Obligation Estimate

Contact Metcalf Plumbing today to receive your estimate.